I bought the Logitech G Pro Wireless mouse last week as my old mouse was getting a bit skanky and I wanted something nice to replace it with.

So far I like it but the one annoyance was that when I turned my PC off or it went to sleep the mouse would start up a lightshow even though I’d disabled the RGB lighting in the Logitech G HUB software.

It turned out that the solution to this was to save a profile without lights to the mouse and use it on-board memory mode so that it remembers to keep the lights off even when the PC isn’t on.


4 Comments

big daddy daddy · 10th January 2020 at 3:11 am

ok this worked like a charm works even on a wired mouse, because when you close g hub it would normally put the lights back on but this fixes the problem

Emil · 3rd February 2020 at 2:19 pm

Thanks, was driving me nuts 🙂

Alex Woodland · 15th April 2020 at 9:44 pm

Thanks so much! This was really annoying. The software is poorly laid out and I didn’t even spot this. Clearly should be on by default anyway. Once again many thanks!

Charles · 26th June 2020 at 11:40 am

I used a knife and cut the internal lighting source. It should not require that level of ‘hacking’. I will never buy another logitech product.

Leave a Reply

Your email address will not be published. Required fields are marked *